What are polyaspartic and polyurea coatings?
Both polyurea and polyaspartic coatings are in existence for more than two decades, mainly used for coating steel to avoid rust. The superior performance led to testing as a concrete covering. They begin as two constituents which are blended basically as epoxy and rolled on a concrete surface. Coloured tints can be applied, and ornamental chips or broadcast into the wet coating. The peak coat summarized the quartz and chips, producing an attractive outcome.
The conventional polyaspartic and polyurea floor coatings are used within only two coats: The first being both the colour coat and primer. And, the second is being the transparent cover. As of their quick cure rates, a full flooring system can be installed in a single day and returned to the service the next day, meaning that you won’t require doing without your garage for 3 to 4 days like you will do for a complete epoxy system.
Here are some top benefits of applying polyaspartic and polyurea floor coatings:
- Have 100 percent U.V. permanence means they will never turn yellow.
- Provide a crystal clear finish that will not redden from moisture in the concrete.
- Have sufficient flexibility for superior impact resistance.
- Provide a high shiny finish.
- There is less likelihood of bubbles from outgassing because of the quicker cure rate.
- Come with a high film build-up that the applicator can control.
- Have supreme wetting traits letting for good diffusion into the concrete for a sturdy connection.
Hunt for the best company of polyaspartic coatings in Council Bluffs to enjoy these benefits.
How much are we likely to invest in the polyaspartic and polyurea flooring system?
Cost is the primary factor that you need to think about. To install this system professionally, you may spend around $2 to $3 per sq ft. on average compared to an equivalent epoxy and polyurethane system.
What is the difference between polyurethane and polyaspartic coatings?
Polyurethane coatings
Polyurethane coatings are less costly than polyaspartic. They are chemical, abrasion, and U.V. resistance. Also, they can be employed in thin film builds, up to 6mil DFT. It has a long pot life which is 1.5 to 2 hours at 75 degrees Fahrenheit.
Polyaspartic coatings
Polyaspartic coatings are alike in application and performance traits to aliphatic polyurethane coatings. They let fast return to service and have a short pot life- 20 to 30 minutes at 70 degrees Fahrenheit. Prefer the most dependable services of polyaspartic coatings in Council Bluffs.